Drone Mapping and Inspections in Latvia

Two services for clients who need data rather than pictures: measurable site mapping from 299 € and structure inspections with a defect report from 189 €. Both are flown and delivered by the same person across Latvia, and both end in a file your engineers, your contractor or your insurer can actually work from.

An orthophoto and an inspection can come from the same visit when the site allows it, which costs less than two separate call-outs.

Two services, one aircraft

Mapping answers how big, how far and how high. Inspections answer what is wrong and where. Each has its own page with the full price list.

Mapping and 3D models

Orthophoto, elevation surfaces and photogrammetric models for sites, corridors and structures.

  • Orthophoto of a site 299 €
  • Large or linear site 449 €
  • 3D model 299 €
  • With DSM and DTM 649 €

Drone inspections

Roofs, facades, chimneys, towers and solar parks, with a PDF report of dated frames and marked defects.

  • One element 189 €
  • Whole building exterior 299 €
  • Full inspection set 499 €
  • PDF report in every package

Both from one visit

A measurable map and a documented defect list from a single flight session, when the site and the airspace allow it.

  • Fewer call-outs, one travel cost
  • Orthophoto and 3D together 399 €
  • Photographs added from 180 €
  • Say so before the date is set

If a repeat survey is likely, say so now. Flying comparable passes next time is what makes the year-on-year comparison valid rather than approximate.

Measurable data, or a defect report?

Mapping answers how big, how far and how high. An inspection answers what is wrong and where. Both can come from the same visit when the site and the airspace allow it. Orthophoto work starts at 299 €, an inspection with a PDF report at 189 €. Open the page that matches your task, or describe the decision behind it and I will say which one fits.

info@dronueksperts.lv Mon to Fri, 09:00 to 16:00 (EET)

How a job runs
And what lands on your desk

Both services are only worth paying for if somebody can act on the result. That is why the deliverable, not the flight, decides how the site is flown.

  1. 01

    You describe the decision

    What the data or the report has to support: a repair, a tender, a warranty claim, a design, a volume calculation. This changes everything downstream.

  2. 02

    Airspace and site check

    I check the geographical zones over the location and coordinate the flight where required, before the date is confirmed.

  3. 03

    The flight is planned, not improvised

    For mapping that means altitude, resolution and both overlaps, frontlap along the line and sidelap between lines. For inspections it means systematic passes element by element.

  4. 04

    Processing

    Imagery becomes an orthophoto, a model or elevation surfaces. Inspection frames are dated, organised by element and the defects marked.

  5. 05

    Delivery

    Georeferenced files in the agreed formats, or a PDF report, usually within a few working days.

  6. 06

    Questions afterwards

    If the result raises a question, I answer it rather than referring you back to the file.

Honest limit: aerial mapping is not a substitute for a licensed surveyor where the law or a client requires one. I will say so plainly rather than let you find out later.

Prices

Everything from both services in one table. Prices apply in the Riga area, and for sites further away travel is included in the quoted price.

Mapping

Orthophoto of a site299 €
Large or linear site449 €
3D model299 €
Orthophoto and 3D together399 €
Orthophoto with DSM and DTM649 €

Required resolution, the area and the shape of the site are what move the price, not the file format.

Inspections

One element, visual inspection189 €
Complex object or two elements249 €
Whole building exterior299 €
Full inspection set499 €
PDF reportIncluded

Every package includes the report with dated frames organised by element and the defects marked.

Combined and repeat work

Orthophoto and inspection togetherBy offer
Repeat survey of a known siteCheaper
Annual or seasonal programmeBy agreement
Several sites in one dayBy offer
Photographs from the same visitFrom 180 €

A portfolio surveyed on a cycle costs less per site, and the comparison between years becomes the real product.

What you receive

Georeferenced orthophotoYes
3D model filesAgreed formats
DSM and DTMOn request
PDF reportDated frames
Usage rightsFull

Delivery usually within a few working days, in the formats agreed before the flight rather than after it.

Data somebody can act on, not a folder of images

Plenty of operators will fly your site and send you files. Somebody on your side then has to work out what the resolution is, which frame shows what, and when it was taken. Here the deliverable is agreed before the flight: the resolution the task needs, the formats your software reads, and a report written for the technician, the contractor or the insurer who will open it.

  • Deliverables and formats agreed before the flight
  • Both overlaps planned for mapping, frontlap and sidelap
  • Inspection report with dated frames and marked defects
  • Comparable repeat surveys for year-on-year work
  • Honest limits stated, including when a surveyor is needed
From 189 € Inspection of one element with a PDF report Get a quote or email info@dronueksperts.lv

What you receive

Agreed before the flight, because afterwards is too late to change the resolution.

  • Georeferenced orthophoto. A measurable aerial map of the site rather than a pretty picture.
  • 3D model. In the formats your software reads, for presentation or for measuring a repair.
  • DSM and DTM. Elevation surfaces on request, where the task needs height rather than plan.
  • Inspection report. Dated frames organised by element with defects marked, in every inspection package.
  • Full usage rights. Pass the files to your engineers, your contractor or your board without asking me.

What these do not replace is a licensed surveyor's certified measurement or a structural engineer's assessment.

What you arrange

  • Before the quote The decision the data supports

    A repair, a tender, a design, a claim or a volume calculation. The answer decides the resolution and the format.

  • Access Permission to be on the site

    I handle the airspace side. You arrange access and warn residents, staff or tenants that a drone will be flying.

  • For comparisons Previous surveys if you have them

    If an earlier orthophoto or report exists, send it. Comparable passes make the new one far more useful.

  • For precision work Ground control, if required

    Where the accuracy requirement is strict, ground control points or a surveyor's input may be needed. I will say so before quoting.

These prices are indicative

I assess every situation individually, because the area and shape of the site, the required resolution, the number of elements, the deliverable formats and the airspace coordination all change the work involved. You therefore receive a fixed price for your agreed scope in the quote, before anything is booked.

The figures on this page apply in the Riga area, and for sites further away travel is included in the quoted price rather than added afterwards. Several sites in one day, a portfolio on a survey cycle and urgent work are quoted in writing.

Tell me what the result has to support

Send me the site, the deliverable you need and the decision behind it. I check the airspace, tell you which service fits and send a fixed price. The assessment is free, and if a simple orthophoto or a single element inspection answers your question I will say so.

info@dronueksperts.lv Mon to Fri, 09:00 to 16:00 (EET)

Request a quote

Fill in the form and I will answer personally, usually within one working day, with the airspace checked and a fixed price for your scope.

Optional. Fill this in if you need an invoice to a company.
Include the country code if you would like a call.
Your booking
This decides the resolution, the deliverable and how the site is flown.
Thank you. Your request has been sent and I will answer personally.
Something went wrong. Please try again or call +371 20387400.

Drone mapping and inspections: frequently asked questions

Answers about prices, accuracy, deliverables, reports, repeat surveys and what you arrange yourself. If your question is not here, call +371 20387400 or write to info@dronueksperts.lv.

01How much does drone mapping cost in Latvia?

An orthophoto of a site costs 299 €, a large or linear site 449 €, a 3D model 299 €, both together 399 €, and an orthophoto with DSM and DTM surfaces 649 €.

03Is the inspection report really included?

Yes, in every package. Without it you have photographs rather than an inspection, and somebody on your side would have to work out which frame shows what.

05What is an orthophoto?

A measurable aerial map of your site, corrected so that distances and areas can be read from it rather than estimated.

02How much does a drone inspection cost?

A visual inspection of one element costs 189 €, a complex object or two elements 249 €, a whole building exterior 299 €, and a full set 499 €.

04What is in the inspection report?

A PDF with dated frames organised by element and the defects marked, written so a technician, a contractor or an insurer can use it without further explanation.

06Can we get both mapping and an inspection from one visit?

Often yes, if the site and the airspace allow it. Say so in advance, because the flight has to be planned for both.

Scroll to Top